Additional Features - Philips SBCVL1100/00 Modo De Empleo

ENGLISH
10
AV SOURCE INPUT AV SOURCE INPUT
R–AUDIO–L R–AUDIO–L VIDEO VIDEO DC 9V DC 9V
CHANNEL CHANNEL
IR IR
1 2 3 4 1 2 3 4
SCART OUTPUT SCART OUTPUT
SBC VL1100 TVLINK TRANSMITTER
SBC VL1100 TVLINK TRANSMITTER
IR SENSOR
VCR
VCR

Additional features

Using the remote control blaster cord
If the video source does not respond to remote control commands, the
remote control blaster cord should be connected.
1 Ensure that the transmitter unit is switched off.
2 Connect the blaster cord to the IR connector (7) of the transmitter
unit.
3 Locate the position of the IR sensor on the video source.
Normally it is located on the front panel, positioned to the left or right
of the display. (See the User Manual of your VCR, DVD or SAT box.)
4 Remove the adhesive tape from the IR light and fix the IR light on the
IR sensor of the video source.
Notes:
– Placing the IR light 5-10 cm in front of the video source instead of precisely
on the device makes finding the exact location less critical.
– Particular brands and types of TV react to remote control signals by making a
buzzing noise when a command is given.
– If you are still having problems getting your configuration to work correctly,
check 'Problem solving'.
– It is possible to control devices of most brands, but some devices from Sagem,
Nokia and Bang & Olufsen cannot be controlled remotely.