Channel Selection - Philips SBCVL1100/00 Modo De Empleo

ENGLISH
8
AV SOURCE INPUT AV SOURCE INPUT
R–AUDIO–L R–AUDIO–L VIDEO VIDEO
CHANNEL CHANNEL
IR IR
1 2 3 4 1 2 3 4
TV OUTPUT TV OUTPUT
R–AUDIO–L R–AUDIO–L VIDEO VIDEO
CHANNEL CHANNEL
1 2 3 4
1 2 3 4
1 Make sure transmitter, receiver and video source are switched on and
2 Switch on the second TV and select the AV channel.
3 Check if the AV content is shown on the second TV.
4 Point the remote control of the connected video source at the receiver.
5 Change the program number (up/down) or toggle between play and stop.
6 Check if the remote control receiver light (10) on the receiver unit blinks
SBC VL1100 TVLINK RECEIVER SBC VL1100 TVLINK RECEIVER
7 Check if the red remote control receiver light (2) on the transmitter unit
SBC VL1100 TVLINK TRANSMITTER SBC VL1100 TVLINK TRANSMITTER
• If the remote control receiver light does not blink, try repositioning the

Channel selection

• Set the CHANNEL switches (6 and 14) on both units to channel 1.
• If interference occurs (e.g. degraded image) set both switches to another
channel.
Both units must always be set to the same channel.
Test operating video sources on your second TV
that a tape or DVD is inserted and playing in the video source.
red.
> This indicates that it has received the remote control command.
blinks red.
> This indicates that it has received the remote control command from the
receiver unit.
transmitter and/or receiver units.
> The remote control receiver light on the transmitter unit should now
blink when a remote control command is given on the receiver side.
If you still cannot operate a video source remotely, connect the remote
control blaster cord.
For this, see 'Using the remote control blaster cord'.