Part List - NORAUTO 2271067 Manual Del Usuario

26. Danger of electric shock! Do not attempt to repair the appliance yourself. Improper
EN
repairs can lead to considerable hazards. In case of malfunction, repairs are to be
conducted by qualified personnel only.

PART LIST

1 Telescopic pull rod
2 ON/OFF button
3
SET button
4 Display
5 UP button
6 DOWN button
7 Side handle
8 Wheel
9 Ventilation slots
10 DC supply cord
11 Lid latch
12 Lid
13 Divider
INSTALLATION
GENERAL INSTALLATION
The following points should be considered when choosing a location to install the unit:
• A minimum clearance of 50 mm must be maintained on all sides of the compressor
cooler.
• The compressor cooler shall be attached to secure anchorage points.
• The ideal mounting position for the compressor cooler is on a flat, horizontal surface.
If the compressor cooler is subject to sideways angles (for example: heal on a boat), it
can withstand sideways angels of 30 degrees.
• Do not place the product near sharp or hot objects.
• Do not place the compressor cooler near loose objects that could fall on the cabinet,
block the ventilation slots and obstruct its operation.
• Never operate the compressor cooler next to flammable liquids or vapours.
OPERATION
BEFORE FIRST USE
Before starting the product for the first time, place the unit in a horizontal position and
leave it in this position for 12 hours. Then, wipe it inside and outside with a damp cloth
for hygienic reasons.
CARRYING THE COMPRESSOR COOLER
The compressor cooler is fitted with two side handle. The handles should be used to lift
and move the compressor cooler. It also has wheels on the back and a telescopic pull
rod for easy manoeuvring.
WARNING: The lid latch must never be used to lift or move the compressor cooler.
CAUTION: The compressor cooler should always be lifted by at least two people.
44
13
12
11
10
9
1
2
3
4
5
6
7
8