Ruwido cyberclick Manual Del Usario página 15

6. Now press the Level-key (image c) again until the
LED (image a) blinks twice. This shows you that
your cyberclick has stored the appropriate code
number.
7. Now check the function of your remote control. If
your cyberclick does not react to the code number
it has found, repeat steps 1 to 6 until you have fo-
und a optimal code number.
ATTENTION!
A new code search begins with the last code number
found in the previous search. When the end of the
code list is reached the LED (image a) will blink three
times. The search is then repeated from the begin-
ning. Please be patient. There may be many codes to
search through before the code for your equipment is
found.
Querying the Code Numbers
You will need this function to query the code found
by the automatic code search, so that you can note it
down in this operating manual.
1. Press the chosen Level key (TV, SAT, VCR, CD,...)
(image c) until the LED (image a) blinks twice.
2. Now enter code 022 for query mode.
ATTENTION!
The first figure of the 3-digit cod-must be entered
within 5 seconds of the LED (image a) blinking twice.
Otherwise the Led will flash once and you will have to
repeat the procedure from step 1.
3. Now press key 1(image l) and count the number of
times the LED (image a) blinks. (For example, if the
LED (image a) blinks twice the first number in your
code is 2).
Now press key 2 (image l) and count the times the
times the LED (image a) blinks. (For example, if the
LED (image a) does not blink, the second number
in your code is 0).
Now press key 3 (image l) and count the times the
LED (image a) blinks. (For example, if the LED
(image a) blinks seven times, the third number in
your code is 7).
Your code number would therefore be 207.
4. If you made a mistake you can repeat the
procedure any number of times.
ATTENTION!
Query mode is terminated if you press any key other
than 1, 2 or 3 or if you do not press any of these keys
within 5 seconds.
NOTE: If the LED does not blink when querying one
of the digits then the corresponding code number
is 0.
13