Inserting And Changing The Batteries; Description Of Keys; Programming Cyberclick - Ruwido cyberclick Manual Del Usario

Inserting and changing the batteries

Your cyberclick is powered by two (alkaline) 1.5 V
batteries (IEC LR 03, AAA)
Insert the batteries following the markings in the
battery compartment.
After inserting the batteries, your cyberclick is
adjusted for PC-operation.
If the LED does not blink as usual when pressing the
keys or if the device you are controlling fails to
respond from the usual distance then the batteries
must be changed.
Your easytip includes a intermediate memory which
prevents the easytip from losing its memory during
the battery changing.
Please dispose batteries carefully.

Description of keys

Image
a Light-emitting diode (LED)
b Power/Standby: on/off
c Level key to switch to device level (TV, SAT,
VCR,...)
d PC: key to get to the PC-mode (PC-operation
possible only with cyberclick receiver)
e Videotext
f +/- Vol: For TV, VCR, SAT: TV volume control
For CD, TAPE, TUNER: Amplifier volume control
g P+/P-: switch to next or previous channel
h Menu/i: For TV Index, S 100, Info
For SAT Call for menu
i Mute: For TV, VCR, SAT: TV sound on/off
For CD, TAPE, TUNER: Amplifier sound on/off
j OK: For TV and SAT: Confirmation-key for menu
• For VCR and TAPE: Recording (press twice)
k • For TV: Using the teletext-function
• For VCR, CD and TAPE: Stop, Play, Rewind,
Fast Forward, Pause
l Number keys 0-9
m 1-: -/--,1-,1*,10,etc.
n 2-: 2-,2*,20,etc.
NOTE: Key on the rear equals Menu/i (h)-key.

Programming cyberclick

Programming by Code entering
1. Switch on the device you want to use your
cyberclick with.
2. Make sure you are outside PC mode. To get out of
PC mode, press PC-key (image d) until LED
(image a) doesnít light anymore.
3. Turn to the TV code list (other manual) and look for
the name of your device manufacturer.
4. TV, VCR, SAT, CD, TAPE, TUNER
Choose the device you want to adjust by pressing
the Level key (image c) and keep it pressed (for
about 5 seconds) until the LED (image a) blinks
twice. Continue with step 5.
AMPLIFIER
Press the Level key "TUNER" (image c) (for about
5 seconds) until the LED (image a) blinks twice.
Then press "TUNER" (image c) again to get to the
Amplifier mode. Continue with step 5.
5. Enter the first 3-digit code from the list with the
number keys (image l) on your remote control.
11