Speaker Stand Installation - ION TOTAL PA Glow Max Guia Del Usuario

User Guide (English)
Introduction
Thank you for purchasing the Total PA
important to us as it is to you. That's why we design our products with one thing in mind—
to make your life more fun and more convenient.
Box Contents
™
Total PA Glow Max
Power Cable (5 ft. / 150 cm)
Microphone with cable (15 ft. / 450 cm)
Remote Control
Speaker Stand
Quickstart Guide
Support
For the latest information about this product (documentation, technical specifications,
system requirements, compatibility information, etc.) and product registration, visit
ionaudio.com.
For additional product support, visit ionaudio.com/support.

Speaker Stand Installation

1. Extend the speaker stand tripod legs on a flat, stable surface. Fully extend the legs until
the plastic bracket is stopped by the bumps on the center pole. Insert the lower pin
directly above the lower adjustment knob and tighten the lower adjustment knob.
2. Raise the mounting pole up to the appropriate height needed and tighten the side
adjustment knob. When raising the mounting pole, make sure the end with the upward
pointing arrow is on the top.
3. Insert the upper pin into the upper pin-hole so the mounting pole stays at your set
height, and tighten the side adjustment knob.
™
4. On Total PA Glow Max, adjust the bottom knob counter-clockwise so the screw is not
blocking the opening.
5. Line up the Total PA
on the pole.
6. Tighten the mounting knob clockwise on Total PA
Note: Remove Total PA
™
Glow Max mounting hole with the speaker stand pole and place
™
Glow Max prior to moving the stand for maximum safety.
™
Glow Max. At ION, your entertainment is as
™
Glow Max.
3