4.2. Setting Date and Time
After new batteries have been
inserted, the default time/date display
will blink. You must then re-enter the
current date and time. To do this,
proceed as listed below. Once set, the
monitor automatically records the time
and date of each measurement:
1. Lift and open the data compartment
from the side of the device as
indicated by the data symbol.
2. If the year is not blinking in the
display, press the small TIME button
next to the clock symbol with a paper
clip and the year will start blinking;
release the switch.
3. Using the two arrow keys on the
front of the monitor you can decrease
(left arrow button) or increase (right
arrow button) the number. Release
the arrow button when the correct
number is reached.
4. To confirm the year and then set the
month, press the TIME button.
5. You can now set the month using the
arrow buttons. (Example: pressing 2
times the right arrow button advances
to 06 for June). To confirm and then
set the day, press the TIME button.
11