Kalorik EPCK 47464 Manual Del Usuario página 23

E2: Means short-circuit of the sensor. If the case:
• Press 'Cancel' and unplug the device.
• Let the unit cool down completely.
• Make sure there is enough water in the pot. Add a little bit of water
in the cooking pot if required
• If the unit is already cool, wait at least 10mins before plugging back
the device.
• The function should then be restored. If the problem persists,
contact Customer Service
E3: Means 'Overheating'. When this happens:
• Stop the cooking process by pressing 'Cancel'. Release the steam
and let the unit cool down before opening.
• Check if there is anything burnt inside or at the bottom of the
cooking pot
• Add a little bit of water in the cooking pot if the water level is very
low.
• Let the unit cool down completely. The function should then be
restored.
If this E3 error message appears again on a regular basis, then it is likely
that the cooking pot or the heating plate inside the base are deformed
and create an uneven heat. The cooking pot or the heating plate
need to be replaced. Please contact Customer service for
maintenance/repair.
E4: The signal switch has malfunctioned. Follow the steps:
• Unplug the unit from the wall outlet
• Wait around 15 minutes to plug it back in
• Press the 'Cancel' button on the pressure cooker and select the
desired setting to begin cooking
• If the problem persists or appears on a regular basis, contact
Customer Service for maintenance/repair.
www.KALORIK.com
23
EPCK 47464 - 200605