AEG RCB53426TX Manual De Instrucciones página 11

Frigorífico-congelador
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
Audible or visual alarm is
on.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FROSTMATIC
or after changing the tem-
perature.
Water flows inside the re-
frigerator.
Water flows on the floor.
Possible cause
The cabinet has been re-
cently switched on or the
temperature is still too
high.
The temperature in the ap-
pliance is too high.
The lamp is in stand-by
mode.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FROSTMATIC function
is switched on.
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent wa-
ter from flowing into the
water collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
ENGLISH
Solution
Refer to "Door Open Alarm/
Indicator" or "High Tempera-
ture Alarm/Indicator".
Refer to "Door Open Alarm/
Indicator" or "High Tempera-
ture Alarm/Indicator".
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation"/"Control
Panel" chapter.
Wait a few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "FROSTMATIC func-
tion".
The compressor starts after
some time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

925054515

Tabla de contenido