6- TROUBLESHOOTING
MOVEMENT SENSOR PAD - NO ALARM
• Sources of vibration & movement, other than your baby's, can be detected by the Sensor Pad and the alarm will
not sound.
• Refer to Warnings 3 to 11 and see STEP 3, TEST THE SENSOR PAD.
MOVEMENT SENSOR PAD - FALSE ALARMS SENSOR PAD LIGHT INDICATOR FLASHING RED
• Sensor Pad False alarms may happen for several reasons, always be sure to immediately check on baby whenever
an alarm sounds:
- Nursery Unit has not been turned OFF after you have removed your baby from the crib
- Make sure there is no bedding between the mattress and the Sensor Pad
- Sensor Pad has not been placed under the mattress properly. Be sure the Sensor Pad is on a flat, firm surface
with the printed side facing up
- The sensitivity level may also need to be adjusted
LOSS OF CONNECTIVITY (NURSERY UNIT BLUE LIGHT FLASHES AND EMITS A BEEP
EVERY 20 SECONDS)
• Bring the units closer together.
• Press and hold for 2 seconds the Nursery Unit ON/OFF button, the Nursery Unit will emit a beep and will flash blue
to confirm connectivity.
NO POWER
• Check or replace batteries.
• Make sure monitor is ON.
8