Installation & Operation - Black Box 2-1 FiberSwitch Guia De Inicio Rapido

2-1 FiberSwitch
____________________________________________________________________________________________________
3. Installation & Operation
The 2-1FiberSwitch is to be used only with the 5.0 Volt DC power supply provided with the unit. (Condor
Model DSA-0151D-05). This power supply satisfies the applicable UL safety standard 60950 that requires
isolation from the AC power source as well as proper grounding. To install the 2-1 FiberSwitch, simply
insert the small barrel connector from the DC supply into the mating receptacle on the rear panel and then
connect the power supply to AC power using the provided cord.
There are three multimode fiber duplex connectors on the rear panel of the 2-1 FiberSwitch labeled as
follows: [TXA RXA], [TXB RXB], and [TXC RXC]. The connector types will be either ST or SC style
depending on the particular model purchased. [TXC RXC] is always used for the common device that will
be alternately attached to either the AA@ or AB@ segments. The knob on the front panel is used to select
which of these two segments, A or B, will be connected to C.
NOTE
In a duplex fiber networking system, one element is used for transmitting data and the other for
receiving data. Make sure that the element carrying data transmitted FROM the remote device TO
the FiberSwitch is connected to the ARX@ side of each duplex connector. The other element would
then connect to the ATX@ side of the duplex connector.
Page 7