Bluetooth Connection - EDIFIER W380NB Manual De Instrucciones

● Noise Cancellation ON/OFF
Note: Noise cancellation is enabled by default when the headphones
are powered on, and only at this time can this button achieve functions
stated above.
●

Bluetooth Connection

•
When powered on and not connected, double press the multi-function
button, wait until the red and blue light flashes alternately, then the
headphones enter pairing state;
•
When powered off, press and hold the multi-function button for
5 seconds, wait until the red and blue light flashes alternately, then
the headphones enter pairing state;
•
Set mobile phone to search and connect to "EDIFIER W380NB", after
pairing is successful, the blue light will flash slowly.
● Connect to Two Bluetooth Devices Simultaneously
•
Pair the headphones with the first device;
•
Restart the headphones; press and hold the multi-function button for
5 seconds to enter pairing state and pair with the second device;
•
Operate the first device to pair with the headphones again, then they
are successfully connected to two devices simultaneously.
Slide this button to switch amongst:
Ambient sound mode
Noise cancellation OFF
Noise cancellation ON