Worx WG508 Manual De Instrucciones página 11

instructions, please refer to ''Assembling the
Blow Tube''. Ensure the Fan cover is closed in
position.
connect the cord on the Motor Housing to the
power supply.
Hold the Blow Tube approximately 7 inches
(180mm) above the ground, turn the
blower on and advance slowly keeping the
accumulated debris in front of you.
Once you have blown the debris into a pile,
you can convert to vacuum mode to collect
the debris.
Using the cyclonic Blower Tube Accessory will
help remove clumps of debris and leaves.
uSiNg tHE VACuuM (See Fig. k)
CAutioN!
the vacuum can throw debris, possibly
causing serious personal injury to the
operator or bystanders.
- do not operate the vacuum without the
Leaf Collection Bag installed or with the
bag zipper open.
- do not vacuum sharp, pointed, or hard
objects that could be thrown through the
fabric of the bag, such as wires, staples,
nails, or rocks.
Ensure the machine is switched off and
disconnected from the power supply.
Remove the Blow Tube and attach the Leaf
collection Bag. Then assemble the Vacuum
Tube.
connect the cord on the power head to the
power supply.
iMPortANt: Always keep the Vacuum Tube
1" above debris. Do not force the Vacuum Tube
into a pile of debris or hold the tube upright
while force feeding debris into the tube.
Either action may clog and damage the
Impeller located inside the Motor Housing.
If the machine starts to vibrate or make
abnormal noise, stop it, unplug the cord, and
check for the cause.
EMPtyiNg tHE LEAF CoLLECtioN BAg
When the bag is full, the power of the suction
will decrease, turn off and unplug the vacuum
from the power source. Empty the Leaf
collection Bag as in Fig. L-M.
Do not store debris inside the Leaf collection
Blower/Vac/Mulcher
Bag. To clean, turn it inside out and shake out
any excess debris. Once a year, hand wash the
bag in soapy water and allow it to air dry.
wArNiNg: Normal usage of the
Leaf Collection Bag causes it to
wear and deteriorate over time. A worn
or deteriorated bag allows small objects
to be thrown through the bag, possibly
injuring the operator or bystanders.
Check the bag frequently. if it is worn
or deteriorated, replace it with a new
worX Leaf Collection Bag.
rEMoViNg CLoggEd dEBriS FroM tHE
iMPELLEr
wArNiNg: wear protective glasses
and gloves.
1. Turn off and wait for all moving parts to
stop.
2. Unplug the tool.
3. Push down the lock button to open the Fan
cover. (See Fig. N)
4. Now you can remove the debris from the
Impeller as shown in Fig. O.
5. check the Impeller for any signs of damage.
If it is damaged do not use and contact your
authorized WORX Dealer.
6. Replace the Fan cover.
sTorAGE
Store the Blower/Vacuum and extension cord
indoors, in a cool dry location, out of reach of
children and animals.
11
EN