Worx WG508 Manual De Instrucciones página 8

dry, and high or locked-up place - out of
reach of children.
17)Maintain Appliance With care - Keep
cutting edge sharp and clean for best
performance and to reduce the risk of
injury. Follow instructions for lubricating
and changing accessories. Inspect
appliance cord periodically, and if
damaged, have it repaired by an authorized
service facility. Inspect extension cords
periodically and replace if damaged. Keep
handles dry, clean, and free from oil and
grease.
18)check Damaged Parts - Before further use
of the appliance, a guard or other part that
is damaged should be carefully checked
to determine that it will operate properly
and perform its intended function. check
for alignment of moving parts, binding of
moving parts, breakage of parts, mounting,
and any other condition that may affect
its operation. A guard or other part that is
damaged should be properly repaired or
replaced by an authorized service center
unless indicated elsewhere in this manual.
8
table 1 Minimum gauge for extension
cords
Volts
120V
240V
Ampere
rating more
than not
more than
0-6
6-10
10-12
12-16
NotE: Only the applicable parts of the Table
need to be included. For instance, a 120-
volt product need not include the 240-volt
heading.
Blower/Vac/Mulcher
Total length of cord in feet
25 50 100
50 100 200
AWG
18 16 16
18 16 14
16 16 14
Not
14 12
recommended
Figure 1 Method of securing extension
cord
cORD SET
For ALL douBLE-iNSuLAtEd
APPLiANCES
1) rEPLACEMENt PArtS
When servicing use only identical replacement
parts.
2) PoLAriZEd APPLiANCE
CoNNECtioNS
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade is
wider than the other) and will require the use
of a polarized extension cord. The appliance
plug will fit into a polarized extension cord
only one way. If the plug does not fit fully
into the extension cord, reverse the plug.
If the plug still does not fit, obtain a correct
150
polarized extension cord. A polarized
extension cord will require the use of a
300
polarized wall outlet. This plug will fit into the
polarized wall outlet only one way. If the plug
does not fit fully into the wall outlet, reverse
the plug. If the plug still does not fit, contact a
qualified electrician to install the proper wall
outlet. Do not change the equipment plug,
12
extension cord receptacle, or extension cord
12
plug in any way.
12
SAVE tHESE iNStruCtioNS
APPLIANcE cORD
(A) tiE Cord AS
SHowN
(B) CoNNECt PLug
ANd rECEPtACLE
EN