Worx WG508 Manual De Instrucciones página 9

syMBoLs
Double insulation
Blower/Vac/Mulcher
AssEMBLy
Before assembling the Blow Tube or Vacuum
Tube, be sure the on/off switch is in position
''O' and the tool is unplugged.
ASSEMBLiNg tHE BLow tuBE
First align the Blow Tube connector and
cyclonic Blower Tube as shown in Fig. A.
Then align the locking pins(a) on the Motor
Housing with the slots (b) on the Blow Tube
connector. Then rotate the tube to the
position to lock it (See Fig. B).
NotE: When assembling , please make
sure the side marked "▼"on the Blow Tube
connector and the side marked "
Motor Housing line up at the same level.
The cyclonic Blower Tube Accessory will
guide air flow to a small area. Assembly of
the cyclonic Blower Tube Accessory is shown
in Fig. c. Push until the hole on the cyclonic
Blower Tube Accessory engages the notch on
the tube.
NotE: Blow Tubes must be assembled
together before use. Ensure the Fan cover is
attached to the Motor Housing.
The machine will not operate in blow mode
without the Fan cover in place.
ASSEMBLiNg tHE VACuuM tuBE
First align the upper and lower tubes as
shown in Fig. D. Make sure the notches
engage the holes on both sides.
Then fit the Vacuum Tube to the Motor
Housing as shown in Fig. E and F .
Push down the lock button on the Fan cover
to open the Fan cover, position the bottom of
the tube on the metal pivot shaft of the cover.
Then as seen in Fig. F , swing the top of the
Tube upward and press the lock button on the
tube at the same time , then lock the Vacuum
Tube into place. check the Vacuum Tube is
firmly secured.
wArNiNg! do not attempt to
operate or disable the on/off
switch.
NotE: After attaching the Blow Tube or
Vacuum Tube to the Motor Housing, you may
later remove it by moving the On/Off switch
to the off position. Do not try to separate the
tubes by force or by using tools, unplug the
"on the
9
EN