Automatic Motor Zoom Control - Metz SCA 3202-M7 Manual Del Usuario

f-number (e.g. f/8 instead of f/11) or the distance
to the subject or to the reflecting surface (for
example, when bouncing the flash) must be re-
duced. Please observe the maximum flash range
of the flash unit.
Some types of flash units (e.g. 40 MZ-3 / -3i,
50 MZ-5, 54 MZ-..., 70 MZ-5 and 76 MZ-5 digi)
may give an acoustic „Beep" signal in addition to
the display. See the operating instructions of the
individual flash unit.
For system induced reasons, correct exposure
confirmation of the flash unit is only fully sup-
ported by the mecablitz 40 MZ..., 44 MZ-2, 45
CL-4 digi, 50 MZ-5, 54 MZ-... , 70 MZ-.... and
76 MZ-5 digi.

4.5 Automatic motor zoom control

On flash units with motor zoom reflector (e.g. 40
MZ-..., 44 MZ-..., 54 MZ-... , 70 MZ-... and 76
MZ-5 digi the reflector's coverage angle, i.e. the
reflector's position, is automatically adapted to the
focal length of the camera lens.
After the flash unit has been switched on the
„Auto Zoom" mode is automatically selected if the
camera is on and activated by touching the shut-
ter release.
In combination with some cameras, the flash
unit's zoom reflector may be extended further than
required for the focal length of the lens. A manual
correction of the reflector's zoom position, how-
ever, will not be necessary!
21