PAPILLON MULTICUTTER 33N Manual De Instrucciones página 34

cod. 97845
'rl apillon
6. Assemble the safe guard. Release hex screws on safe guard fixed base, and then fix the
safe guard with hex key and wrench enclosed as standard accessories for tightening the
nuts enough.
Warning! Use only original manufacturer's replacement parts, accessories and attachments.
Failure to do so can cause poor performance, possible injury and may void your warranty.
Never use the machine without the guard assembled!
7. Assemble the cutting head.
3.4 Release the nut. Line up the two holes of flange and shield, use one hex key to hold the
flange as below and turn the socket wrench clockwise, the nut will be released.
3.5 Fit the Nylon cutting head. Remove another shield after release the nuts as picture
showing. Still hold the flange, take the Nylon cutting head on the shaft and rotate
counter-clockwise, the Nylon cutting head is fitted.
3.6 Release the Nylon cutting head. Use screw driver to hold the flange and then rotate the
Nylon cutting head clockwise, it will be replaced.
34