Getting Started; Operating; Setting The Functions - Medisana WBB Instrucciones De Manejo

GB
2 Getting Started / 3 Operating
2.1
Items supplied
and packaging
2.2
Foot bath and
water massage
2.3
Foot massage
without water
3.1
Filling with water
3.2
Setting the
functions
3.3
Aromatic
substances
6
Please check first of all that the unit is complete.
The following parts are included as standard:
• 1 MEDISANA foot spray bat WBB
• 4 Massage inserts
• 1 Instructions for use
The packaging can be reused or recycled. Please dispose properly of any pack-
aging material no longer required. If you notice any transport damage during
unpacking, please contact your dealer without delay.
WARNING
To avoid risk of suffocation, keep packaging film away
from children!
Before filling the device with water, make sure that no mains leads are con-
nected, i.e. the electricity lead must not be plugged-in!
When the foot spray bath is securely placed on the floor (ensuring that it
cannot tip over), and has been filled with water, insert the mains plug into the
power supply socket.
You can also use the device for a foot massage without water - for this mode
switch the Rotary switch
The foot spray bath WBB can be filled with up to 3.3 litres of water. The
maximum filling height is marked
or warm water with or without bath additives.
Sit down comfortably in front of the foot spray bath and select one of the three
different functions using the Rotary switch. All three positions make use of the
heat function, i.e. the water is kept at a constant temperature for up to 20
minutes. However the device is not designed to heat water, i.e. if you fill it with
cold water, the water will remain cold.
Remove the cap and place the aromatic substances and bath oils in the
depression located below. During operation of the device, the additive will
slowly be mixed into the water.
Never use any foaming bath additives or bath salts.
to position 2 (massage and heat function).
in the foot spray bath. You can use cold