Ceiling Mount; Service And Repairs; Warranty - DeWalt DCE089G18 Manual De Instrucciones

CAUTION:
These glasses are not ANSI
approved safety glasses and should not
be used while operating other tools. These
glasses do not keep the laser beam from
entering your eyes.
CAUTION:
To reduce the risk of serious injury,
never stare directly into the laser beam with or
without these glasses.

Ceiling Mount

The laser ceiling mount (Figure
offers more mounting options for the laser. The ceiling
mount has a clamp (Figure
be fixed to a wall angle for acoustic ceiling installation
(Figure ). At each end of the ceiling mount is a
L 3
screw hole (Figure
L 4
mount to be attached to any surface with a nail or screw.
Once the ceiling mount is secured, its steel plate
provides a surface to which the magnetic pivot bracket
(Figure ) can be attached. The position of the
L 6
laser can then be fine-tuned by sliding the magnetic
pivot bracket up or down on the wall mount.

Service and Repairs

NOTE: Disassembling the laser level(s) will void
all warranties on the product.
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by
authorized service centers. Service or maintenance
performed by unqualified personnel may result in a risk
of injury. To locate your nearest D
go to www.2helpU.com.
), if included,
L 1
) at one end which can
L 2
and ), allowing the ceiling
L 5
Walt service center
E

Warranty

Go to www.2helpU.com for the latest warranty
information.
GB
19