Publicidad
Idiomas disponibles
Idiomas disponibles
FORK BLOCK, SKEWER, AND WHEEL TRAY ASSEMBLY
Attach the Fork Block and Skewer
Housing to the front crossbar using the
Hex Key, bolt and washers as shown.
5/16" Bolt
Fork Block
Crossbar
5/16" Hex Key
BEFORE LOADING YOUR BIKE
• Fork Block may need to be
rotated to fit your bike.
• Be sure the Skewer moves
freely in the housing (ie., not
rusted).
• Insert forks straight up and
down.
• Do not use Skewer if it is bent
or does not move freely.
• Check and lubricate frequently.
Loosely install the Quick
Release Skewer and
skewer nut.
Skewer
Housing
Pull the SnapAround open (it will
not break) and slip it on the rear
crossbar, "ear-up". Assemble bolt
Ear
Hex Key
Quick Release
Skewer Lever
and Hex Key loosely. Slide the Wheel
Tray over the bolt head and ear.
Tighten the Hex Key.
LOADING YOUR BIKE
Remove the front wheel from
your bicycle and move the
Skewer Lever into the open
position. Set your bicycle's rear
wheel in the Wheel Tray and its
fork straight down onto the
Skewer.
Make sure the front drop-outs are
completely down on the ends of
the skewer. (If you have difficulty
removing your bike forks from
the Skewer, throw open the
Skewer Lever and loosen the
Skewer Nut.)
Skewer Nut
Wheel Tray
Publicidad
