Assembly Step 10: Heat Indicator Installation; Assembly Step 11: Nameplate Installation - Weston 41-0701-W Manual De Instrucciones

ASSEMBLY STEP 10: HEAT INDICATOR INSTALLATION

HARDWARE
NUT
NOTE: This Nut is already threaded onto the
Temperature Gauge and must be
removed for assembly.
1. Remove the Nut from the back of the Temperature Gauge and insert
the Temperature Gauge into the Door Panel. FIGURE 17 Make sure the
Temperature Gauge numbers are positioned right side up. FIGURE 18
2. From the back side of the Door Panel, place the Washer on, then
thread the Nut onto the Temperature Gauge.
3.Tighten the Nut firmly, but do not over tighten.

ASSEMBLY STEP 11: NAMEPLATE INSTALLATION

LOCATE THESE PARTS
NAMEPLATE
ASSEMBLY STEP 12: SECURING THE HVR
LOCATE THESE PARTS
S-HOOK
12
HARDWARE BAG
WASHER
TEMPERATURE
GAUGE
2 PUSH NUTS
HARDWARE BAG
E
TOOLS NEEDED
1/2" WRENCH
1. Insert the Name Plate mounts
through the mounting holes in
the front of theDoor Panel.
FIGURE 19
2. From the inside of the Door
Panel, securely attach the
Push Nuts to the Name Plate
mounts.
1. Place one end of the S-Hook
F
around the HVR neck. FIGURE
20
2. When an LP tank is not
attached to the Smoker, use the
S-Hook to hang the HVR from
the Carry Handle on the
side of the Smoker. This will
help prevent dirt and other
particles from plugging the end
of the HVR.
ASSEMBLY IS NOW
COMPLETE!
Please follow all instructions
and safeguards on the following
pages for connecting the LP
tank.
FIGURE 17
FIGURE 18
FIGURE 19
FIGURE 20