Assembly Step 3 Control Panel / Hvr System / Ignitor Installation - Weston 41-0701-W Manual De Instrucciones

ASSEMBLY STEP 3 CONTROL PANEL / HVR SYSTEM / IGNITOR INSTALLATION

LOCATE THESE PARTS
IGNITOR
KNOB
HARDWARE
1. Leave the Cabinet positioned upside down.
2. Attach the Ignitor Knob and the Control Knob to the Control
Panel Assembly. FIGURE 5 Make sure the Control Knob
properly seats on the keyed shaft. FIGURE 6
3.Line up the Control Panel. FIGURE 7
4.The (Hose/Valve/Regulator) HVR stem must be inserted into
the Venturi. FIGURE 8 WARNING! Improper installation may
cause a fire outside of the Smoker!
5.When sliding the Control Panel into place, make sure the tabs
capture the front Legs. FIGURE 9
6.Connect the Ignitor wire to one of the prongs on the Ignitor.
FIGURE 9
7.Insert the 2 remaining Bolts from Hardware Bag A through the
tabs on the Control Panel and thread them into the mounting
holes. FIGURE 8
8. Firmly tighten all of the Bolts, including the loose Bolts
on the front Legs.
REMAINING
BOLT
HVR STEM
inserted into the
VENTURI.
8
CONTROL
PANEL
ASSEMBLY
CONTROL
KNOB
NOTE: Hardware Bag
A includes 12 Bolts.
You will need 2 bolts
2 BOLTS
for this step. The other
10 bolts were used in
Step 2.
Be sure the tab fits
around both sides
of the LEG.
FIGURE 8
HVR
ASSEMBLY
A
HARDWARE BAG
IGNITOR
KNOB
IGNITOR WIRE
connects to
the IGNITOR.
TOOLS NEEDED
Tools needed:
PHILLIPS
HEAD
SCREWDRIVER
CONTROL
PANEL
ASSEMBLY
VENTURI
HOSE
FIGURE 9
FRONT
TOP
FIGURE 5
CONTROL
KNOB
FIGURE 6
FIGURE 7