Preparation; Installing The Hanging Bracket - Hinkley CROFT Manual De Instrucciones

Ventilador interior
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PREPARATION

PREPARATION:
Verify you have all parts before beginning
the installation. Check foam insert closely for
missing parts. Remove motor from packing.
To avoid damage to finish, assemble motor
on soft padded surface or use the original
foam inset in motor box.
DO NOT LAY MOTOR HOUSING ON ITS SIDE
AS THIS COULD RESULT IN SHIFTING OF
MOTOR IN DECORATIVE ENCLOSURE.

INSTALLING THE HANGING BRACKET

CAUTION: To avoid possible electrical shock, be sure electricity is turned off
at the main power box before wiring. All wiring must be in accordance with
National and Local Electrical Codes and the ceiling fan must be grounded as
a precaution against possible electric shock.
Locate ceiling joist where fan is to be mounted, being sure location
1
agrees with the requirements in the minimum clearance section of this
guide. Wood joists must be sound and of adequate size to support 35
pounds (See page 2, items 3 and 4).
If not already present, mount a UL listed outlet box marked "suitable for
2
fan support" following the instructions provided with the outlet box. The
outlet box must be able to support a minimum of 35 pounds.
Attach hanging bracket to outlet box using screws provided with the
3
outlet box.
Canopy
Downrod
Blade
Detachable
Switch Housing
Parts identification on assembled fan.
Flat Washer
Spring Washer
Yoke Cover
Motor Housing
Pull Chain with Fob
LED Light Kit
Ceiling Fan
Outlet Box
Hanger
Bracket
Outlet Box
Screw
Fig. 1
©2021 Hinkley Lighting, Inc. | hinkley.com |
05

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido