Emergency Recording - Aukey DR02 Manual De Usuario

● Motion Detection Recording: Switch on motion detection in 'Setup.' This function
is designed to monitor when you've parked and left your vehicle but requires
a continuous power supply. It will record video each time motion is detected
by the front or rear camera
● Time-Lapse Recording: Switch on time-lapse recording in 'Setup.' This function
will capture a picture per second to make a video played at 30fps

Emergency Recording

● Manual File Backup
Press to back up the current file so that it won't be overwritten. A
will appear in the top left of the LCD screen to indicate a protected emergency
recording is in progress
● Auto File Backup
Once the G-sensor is activated by a sudden impact, the device will automatically
make a recording and protect it from being overwritten. Adjust G-sensor sensitivity
in the 'Setup' menu
Note: Enter the playlist or setup menu (or disconnect power) to end emergency
recording mode.
Snapshot
● Hold down
● The snapshot files are located in the \AUKEY\PHOTO folder on the micro
SD card
● The
icon will be shown after you take a snapshot. This won't interrupt the
video recording
for 3 seconds to take a snapshot while in recording mode
- 10 -
icon