How To Use - Aigostar 8433325504786 Manual Del Usuario

GB
220-240V 50/60Hz 700W
STRUCTURE OF THE PRODUCT
11
10
9
8
Handle
1
Release button
2
Power button
3
4 Cord rewind button
Air Outlet Plate
5
6 Big wheel
01
12
1
2
3
4
5
6
7
Dust cup
7
Hose connector
8
Brush tool
9
10 Hose
Extending metal tube
11
12 Two in one brush
SAFETY DIRECTION
1.For the first operation, it is advisable to read the manual carefully before hand and
keep it properly for future use.
2.Before the first operation, make sure the dust cup is properly installed.
3.Make sure the power supply is 220-240V ~50Hz
4.Do not vacuum water and inflammable material
5.Do not vacuum burning material and ashes
6.Do not use the machine without a motor protection filter filled
7.Please change the dust cup/HEPA immediately when it is damaged.
8.Do not store or use the machine close to high temperature places
9.Do not let children use the machine in case of any danger
10.If abnormal noise, smell, smoke or any other failure or breakage was found during
the operation, you should turn off the switch and unplug it. Then contact with your
service center for repair. Do not repair it by yourself.
11.If the supply cord is damaged, it must be replaced by the manufactures or its
service agent or a similarly qualified person in order to avoid a hazard

HOW TO USE

ASSEMBLY BEFORE USE
Fig.1 shows the connection of the hose and the vacuum cleaner:
Put the hose connector in front of the vacuum cleaner .Then insert it into the inlet
hole and turn right. If you want to disassemble it, you can turn the hose connection
left and then pull it out.
Fig.2 shows the connection of the hose and the extending metal tube:
Hold the flexural connector of the hose and put it into the bigger hole of the tube.
Fig.3 shows the connection of the tube and the brush tool:
Put the metal tube into the hole of the brush and rotate it to fasten them.
Fig.4 shows how to check the winding of the power cord.
You can pull the power cord out of the machine and stop it when you see the yellow
mark. Make sure the red mark is not out. When your sweep is over, firstly turn off the
power, pull the plug out of the socket, and then push the winding device button until
the cord is completely in the machine.
Fig.5 shows the power button
Put the plug into the socket, push the power button to control the work of the
machine.
GB
02