allen+roth 1227VA-36-201 Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS
4. Insert bolts (AA), spring washers (EE) and
washers (BB) into the predrilled holes on the
inside of the legs (B), tighten with allen
wrench (DD).
Hardware used
Bolt
AA
Washer
BB
Allen wrench
DD
Spring washer
EE
Note: Clean area where the vanity (A) will be
permanently located prior to beginning installation,
ensuring the vanity (A) will not interfere with any
water supply and drain lines once mounted.
Note: Use preassembled levelers on legs of
vanity (A) to level the item. Twisting the
levelers counterclockwise will increase the
height of vanity (A), twisting them clockwise
will decrease it.
5. With two people, carefully place vanity (A) with
top (D) against the wall in its final location.
From inside vanity (A), drill hole through vanity
mounting area and into wall studs. Using
mounting hardware (not included) appropriate
for your installation site, secure vanity (A) to
wall stud. If possible, secure vanity (A) to
two wall studs for increased stability.
WARNING
Vanity (A) MUST be secured to wall.
4
AA
EE
BB
x 4
x 4
x 1
A
x 4
5
6
DD
B
D
A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

0819968

Tabla de contenido