S-Bus / Data Communication - oventrop Datalog CS-BS-1 Manual De Uso E Instalación

3.3

S-Bus / Data communication

The Datalog CS-BS-1 is connected to the controller via the pre-connected S-Bus
cable. The corresponding terminal allocation is described in the controller manual.
The S-Bus can be extended using the terminal block included and a common two-
wire cable (twisted).
 
Connection terminals of the Datalog CS-BS-1
The S-Bus cable is pre-connected to the Datalog CS-BS-1 terminals
22
1
2
 
and
.
5
3.2
3
4