HumanTechnik CM-1 Instrucciones De Servicio página 32

No. Control feature Function and application CM-1 transmitter
7 Frequency
selector switch
8 Battery compart- The battery compartment is located on the back of the device
ment cover
9 Recording
device
pendant cord
Inserting the batteries into the CM-1 transmitter:
The device runs on two rechargeable "AAA"-type batteries. It can also run on non-
rechargeable batteries.
Where necessary, only use original replacement batteries.
If you run your CM-1 communication system on disposable batteries, don't place the
transmitter onto the CM charger.
There is a slide switch on the back of the device for setting
the following 3 frequency ranges:
Switch A
setting B
C
Slide the selector switch to the required frequency position using
the supplied pin.
Bear in mind at all times that the CM-1 transmitter and the CM-1
receiver have to be set to the same frequency ranges.
Different frequency ranges prevent each transmission.
and holds both batteries.
Insert the knob of the pendant cord into the circular part of the
device and engage the knob perceptibly by pushing it towards
he tip of the device.
863,725 MHz
864,225 MHz
864,725 MHz
English 31