Charger; Transport Pouch - HumanTechnik CM-1 Instrucciones De Servicio

Interconnecting two CM chargers
1. Disconnect the two chargers, which you wish to join, from the mains supply.
2. Detach one bridge element from the base of one of the chargers.
3. On the first charger, remove the plastic covers from the bridge element connector slot.
Slide the bridge element into the connector slot.
4. Fix the bridge element in place through the underside of the device base using the
supplied screws.
5. Remove the corresponding plastic cover from the second charger.
6. Place the second charger onto the bridge element that protrudes out from the first

charger.

7. Slide the second charger flush against the first charger.
8. Fix the second charger in place through the underside of the device base onto the
bridge element using the supplied screws.
9. Connect one of the two chargers to the power supply unit by inserting the round
connector of the power supply unit into the DC jack on the back of the CM charger.
!
Where there are two chargers connected together, only use one power supply unit!

Transport pouch

34 English