Kohler K-2816 Guia De Instalacion página 5

Marble
Setting Tool
Anchor
Foam
Padding
Clamp
Wood
Screw
Anchor
Screw
Undercounter Installation
2. Install the Lavatory/Sink
Undercounter Installation
Cut out the opening by carefully following the pencil line traced
from the template.
NOTE: The screws and anchors provided should be used on
countertops with a minimum 1" (2.5 cm) thickness. For thinner
countertops, use appropriate anchors and fasteners (not provided).
For Wood Countertops
Mark and pre-drill the wood screw holes at the locations shown
on the template.
Waterproof any exposed areas of wood.
For Marble/Stone Countertops
Position the countertop upside down on foam padding to protect
the surface. Mark and drill 3/8" holes 5/8" (1.6 cm) deep at the
locations shown on the template.
Use a setting tool and hammer to secure the anchors.
For All Undercounter Installations
If the countertop has not been installed, install it at this time.
Drill the faucet holes according to the faucet installation
instructions.
Kohler Co.
Lavatory
Route or shim
as required to
level tile.
Water Resistant Underlayment or
Apply
Backing Material 3/4" (1.9 cm)
sealant.
Minimum
Tile-In Installation
5
Sealant
Tile
Mortar or
Adhesive
1018893-2-E