How To Operate; Bulb Replacing; How To Clean - Nevir NVR-5202 NSD Instrucciones De Operación

HOW TO OPERATE

Starting Your New Fridge
1. Clean the fridge thoroughly. Wipe the outside with a soft dry cloth, the interior with a clean
moist cloth.
2. Insert the power supply cord into the socket.
3. Turn the thermostat dial to "7". Close the door and let the fridge operate for 15-20 minutes.
Temperature Control
To control the internal temperature, adjust the thermostat dial. "1" is the warmest setting. "7" is
the coldest. The Dial may be set any place on the scale. It does not have to be set exactly on a
number.
Note: Wait 3-5 minutes before restarting if you unplug the fridge.
The unit may fail to operate properly if restarted too quickly.

Bulb replacing

1. Switch off the refrigerator and pull out power cord from wall socket. Wait some minutes till
the bulb becomes cold.
2. Remove the lamp shield by removing a screw that fixing the shield.
3. Screw out the old bulb and replace a new bulb (Max. 10W)
4. Reinstall the lamp shield and fix it by the screw previously removed.

HOW TO CLEAN

Cleaners: Never use harsh, abrasive cleaners, heavy-duty cleaners, or solvents on any surface.
Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains and for periodic
waxing, use silicon wax.
Interior: Wash shelves and other removable parts in warm sudsy water, rinse and dry. Wash
interior with baking soda solution (3 tablespoons to I liter of water) or warm sudsy
water, rinse and dry.
Magnetic Door Seals:
The Finishing Touch:
Wash with warm sudsy water.
Replace all parts and return thermostat dial to desired setting.
6