Blade Assembly; Switch Housing Assembly - Ellington AVL56BNK5RW Guia De Instalacion

8. Blade Assembly.

motor housing
Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in hardware pack. Hold blade arm up to blade
and align holes. Insert 3 blade attachment
screws (along with washers) with fingers first
blade attachment
screws and washers
and then tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
plastic
motor
Remove blade arm screws and lock washers
lock
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (save blade arm screws and
lock washers to secure blade arms). Align blade
blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
blade arm
screws. Before securing screws permanently,
repeat this procedure with remaining blade
arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
lock
washers
blade arm screws

9. Switch Housing Assembly.

motor housing
Remove finial from switch housing cap
(save finial for later use).
Remove 1 screw from fitter plate (on
underside of motor) and partially loosen
the other 2 screws. Align slotted holes in
fitter
switch housing cap with loosened screws
plate
in fitter plate. Twist switch housing cap
to lock. Re-insert screw that was
previously removed and tighten all 3
switch housing cap
screws securely.
Attach the finial plate with the finial that
was just removed.
finial plate
finial
page 7