Publicidad
Idiomas disponibles
Idiomas disponibles
heater is unplugged from the outlet.
5. Press the Power & thermostat knob will start
the heater.
6. Upon turning the heater on, the unit will be in the
HIGH heat mode (1800 watts), the LCD will
display the current air temperature, and the fan
start to run. At the same time the "HIGH" in the
LCD will be highlighted.
7. When « Mode » button is pressed at this point,
the heater will be set into LOW heat mode (1100
watts) and the "LOW" in the LCD will be
highlighted.
8. Pressing the « Mode » button once more will set
the heater into AUTO mode (1800 watts). Notice
that the display now displays a SET TEMP
indicator (see THERMOSTAT INSTRUCTION).
9. Press the "Mode" button again and the heater
will be in the FAN mode (20 watts). The "FAN" in
the LCD will be highlighted. Fan mode is for fan-
only operation, without any heat output.
Pressing the « Mode » button again and the heater
will go back to HIGH heat mode. Continuing to press
the "Mode" button will cycle the unit through HIGH,
LOW, AUTO, FAN mode.
10. Press « OSC » button, the heater will oscillate
back and forth. Press it again and the oscillation will
stop.
To turn the heater off, press the « Power &
Thermostat knob », and turn off the power switch,
then remove plug from outlet.
Timer Function:
The "TIMER" function allows users to set the
time from 1 to 8 hours, and it is available under
all
HIGH/LOW/AUTO/FAN
"TIMER" is off, pressing "TIMER" button will
start this function and the right side of LCD
screen displays 1,press again, it displays 2, then
3,4,5...8. "TIMER" turns to off after pressing the
"TIMER" button while LCD displays 8, if press
again, timer function will be restarted. "TIMER"
will count down the hours in one hour increment
until the machine turns to standby mode
automatically. If the machine is on standby
mode, press "POWER & THERMOSTAT" knob
can restart it.
PS: Nothing displayed on the right side of the
LCD screen means timer function is off.
WARNING: METAL MESH IS HOT WHEN
HEATER IS IN OPERATION.
THERMOSTAT INSTRUCTION :
1. Pressing the « Mode » button until the
display shows AUTO mode.
2. To adjust set temperature, Rotate the "Power
& Thermostat knob" clockwise to increase
the desired temperature and counter-
mode.
When
Publicidad
