Remote Control - PURLINE HEATY 183E Manual Del Usuario

clockwise to decrease the desired
temperature.
3. When the air temperature raises 2 or 3
degrees above the set temperature, the
heater will stop heating at once and stop
blowing after 15 seconds.
4. When the air temperature drops below the
set temperature, the unit will come back on.

REMOTE CONTROL :

1. Plug the heater into outlet and open the
power switch on the side of the base.
2. Press the POWER button will start the
heater.
3. The OSC, TIMER and MODE buttons
function in the exact same manner as listed
in the operation instructions above.
4. The TEMP. Buttons (▲,▼or + ;-) are for the
thermostat function in the exact same as
rotating the Power & Thermostat knob.
5. The remote control is powered by two AAA
batteries. There is a cover on the back of the
remote control that can be removed for
replacement of the batteries as required.
6. Do not mix old and new batteries, or batteries
of different specifications.
7. The batteries must be removed from the
appliance before it is scrapped; it is to be
disposed of safety.
SAFETY FEATURES.
1. This heater is equipped a thermal overload
protector to prevent overheating.
2. When an overheat temperature is reached,
the heater will be automatically shut off. It can
only resume operation when the user resets
the unit. (see RESET INSTRUCTIONS)