Sauder 418735 Manual De Instrucciones página 11

Step 7
Carefully turn your unit over onto its front ed es. Unfold the
å
BACK (I) and lay it over your unit.
Make equal mar ins alon all four ed es of the BACK (I). Push
å
on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (I) to your unit usin the NAILS (1N).
å
NOTE: Do not tap NAILS into the holes that line up over the
å
SHELF (H) at this time.
Fasten the SMALL BACK (J) to your unit usin the NAILS (1N).
å
NOTE: The SMALL BACK (J) overlaps the BACK (I). Be sure to
å
tap nails in the holes that line up over the SHELF (H).
Usin your hammer, ently tap four TACK GLIDES (12E)
å
into the bottom ed es of the ENDS (C and E) and
BASE MOLDING (M34).
C
12E
www.sauder.com/service
These holes must line
up over the SHELF (H).
J
M34
E
For support, place packin
foam and ma azines here.
418735
Caution
Do not stand the unit upri ht without the
BACK fastened. The unit may collapse.
NAIL
(57 used in this step)
I
I
J
H
1N
Pa e 11