Yakima KingPin 2 Manual De Instrucciones página 3

INSERT MAST INTO
VEHICLE'S HITCH.
IF SPARE TIRE CAUSES
INTERFERENCE, DO NOT
USE THIS PRODUCT!
Align the holes in the receiver
to the holes in the tongue.
EXTEND CARRIER ARMS:
Release wire lock, pull pin out.
Attach one rubber strap to each
cradle and stabilizer.
1033249D-3/15
INSTALL LARGE BOLT
AND LOCK-WASHER.
Install bolt from right side
TIGHTEN with 7/8" wrench.
Raise arms...
stabilizer
of receiver.
CRADLE
POSITIONING
To slide cradles along the
carrier arms, close cradle
and stabilizer.
Close cradles while
loading bikes.
PUSH THE
SAFETY CLIP ONTO
THE EXPOSED END OF
THE BOLT.
Replace safety pin
and wire-lock.