NGP 320 Instrucciones De Instalación

WARNING: Vinyl products can expose you to chemicals including DINP Diisononyl phthalate,
which is known to the State of California to cause cancer. For more information, go to
www.P65Warnings.ca.gov.
1-1/2"
3/4"
1/2"
1/8"
Max.Drop
This product is designed to fit in a 3/4" deep channel in the bottom of a Hollow Metal Door.
1. Cut door bottom 1/8" less than inside length of door channel. DO NOT EXTEND DROP BAR WHILE
CUTTING. Do not cut from end with adjusting rod. MAXIMUM CUT door bottoms 36" and longer = 4",
shorter than 36" should not be field cut - order net length.
2. Drill 1/4" hole for adjusting rod in center of hinge edge of door 1/2" on center from bottom of door.
3. Position door bottom in bottom of door and mark screw holes.
4. Drill pilot holes for screws using 5/64" drill bit.
5. Install with screws provided.
6. Set adjusting rod for proper seal. To reduce drop, turn adjusting rod right; to increase drop turn left. Maximum
drop = 1/2". CAUTION: When adjustment reaches maximum drop, rod will stop turning easily. Do not force
beyond maximum 1/2" drop or damage will occur and void warranty.
National Guard Products Inc.
320
Automatic Door Bottom
Installation Instructions
1-800-647-7874