WARNING: Vinyl products can expose you to chemicals including DINP Diisononyl phthalate,
which is known to the State of California to cause cancer. For more information, go to
www.P65Warnings.ca.gov.
NOTE: Install seals before the closer. Seals installed at head will require the closer body be installed
1/4" lower on the door.
1. Cut seal to fit.
2. Drill head piece for mounting screws, avoiding the area where the closer shoe will be located.
3. With door closed, position seal with the gasketing slightly compressed against the door.
4. Install with TEK screws provided, working from one end to the other.
700EN, 700ES, 700N, 700S, 706, 706E, 9700, 9700E, 9706E
POSITIVE PRESSURE TESTED GASKETING MATERIALS
FOR FIRE DOORS
FOR APPLICATION TO HOLLOW-METAL-TYPE FIRE DOORS
RATED UP TO 3 HOURS AND WOOD-TYPE FIRE DOORS
RATED UP TO 1-1/2 HOURS
Smoke and Draft Control gasketing (Category H) tested to UL 1784; meets
requirements of NFPA 105, IBC for use on "S" label doors. APPLIES TO
700EN, 700N, 700ES, 700S, 706, 706E, 9700, 9700E, 9706E ONLY.
National Guard Products Inc.
700/700E
9700/9700E Series
Perimeter Seals
Installation Instructions
CATEGORY H
1-800-647-7874
700EU, 700U, 701EP, 701P, 703EV, 703V, 704EV, 704V, 705EV, 705V
POSITIVE PRESSURE TESTED GASKETING MATERIALS
FOR FIRE DOORS
FOR APPLICATION TO HOLLOW-METAL-TYPE FIRE
RATED UP TO 3 HOURS AND WOOD-TYPE FIRE DOORS
RATED UP TO 1-1/2 HOURS
10.18
DOORS
CATEGORY J