NGP L-SG100 - TB Instrucciones De Instalación

HOLLOW
METAL
DOOR
1 1/4"
16 ga. STEEL
3/4" X 3/4"
SECURITY
GRILLE
1/8" to 1 1/8"
Glass
1 1/4"
WOOD
DOOR
1 3/4"
3/16"
3/16"
FIELD PAINTING: for best results scuff finish with a Scotch-brite pad or sand paper before painting.
7.20
Fire Door Glass
Light Frame
National Guard Products Inc.
L-SG100-TB
for 1-3/4" Doors
1. Cut out door in accordance with door manufacturers listing procedure. Steel fire-
rated doors do NOT require an opening reinforcing channel or reinforcing clips.
2. Install glass & glazing material (sold separately), into lite kit.
3. Position outer frame in door cut out.
4. Position inner frame and insert and start all screws before fully tightening.
5. Tighten screws using a criss cross pattern. Use caution when using power
screw driving equipment to avoid stripping the material.
For Fire Rated Doors, using 1/4" fire rated wire glass:
20 & 45 minutes = 1,296 sq. inches max visible glass, 54" max height, 54" max width.
60 & 90 minute = 100 sq. inches max visible glass, 33", max height, 10" max width.
Sizes exceeding those shown above may be achieved using Pyran
Pyran Platinum L, Protect3™, TEMP20™, SuperLite™ X-90 or SuperLite™ II-XL.
®
Maximum size is determined by the glass listing (in doors) and door manufactur-
ers listing.
UL10C Positive Pressure rated fire doors using 1/4" wired glass:
20 min. requires closed cell PVC foam glazing tape like NGP L-GT-116, L-GT-118,
L-GT-132 or L-GT-316.
45, 60, 90 min requires NGP 9800C or 3M GIS intumescent glazing tape.
UL10C Positive Pressure rated fire doors using Pyran
Platinum L, Protect3™, TEMP20™, SuperLite™ X-90 or SuperLite™ II-XL
requires closed cell PVC foam glazing tape like NGP L-GT-116, L-GT-118,
L-GT-132 or L-GT-316.
1-800-647-7874
Installation Instructions
Platinum F,
®
Platinum F, Pyran
® ®