Manual Accumulation - Uline H-1649 Manual De Instrucciones

MANUAL ACCUMULATION

When the scale is set for manual accumulation:
1. Press the ACC key
in the memory when the weight is stable.
2. Display shows
ACC 1
memory for two seconds before returning to normal.
3. Remove the weight and allow the scale to return to
zero, then add a second weight.
4. Press ACC , the display shows
Acc
5. Continue to remove and add weights and press
ACC until all weights have been added.
Acc
6. To view the totals in memory, press ACC
the scale shows zero. The display shows the total
number of items
ACC xx
then returns to zero.
To clear the memory:
1. Press ACC to display the totals.
Acc
2. Press the FUNC/C key
NOTE: ACC function is only available when the
stable indicator "O" is on.
To set functions, press the FUNC
at the same time. Scroll through functions by pressing
%
/< or LIMIT/>
% Limit
functions in this order:
CHANGE SCALE WEIGHT INCREMENT
To minimize effects of vibration, wind or other conditions:
• Example: If scale normally weighs in increments of
0.5g, the value can be changed to 1.0g or 2.0g to
get a more stable reading.
1. Display shows
Inc xx
default weight increment.
2. Press the TARE/^ key
3. Press ZERO/ENTER
Zero
BACKLIGHT CONTROL
Backlight is set to operate automatically, turning off
when the scale is not being used. Turning the backlight
off helps maximize battery life.
PAGE 5 OF 27
OPERATION CONTINUED
Acc
to store the displayed weight
and then the total stored in
and the new total.
ACC 2
Acc
and the total weight and
to clear the memory.
Func
Func
and ACC
– the scale will go through the
. The first value shown is the
to change the default.
Tare
to set the new weight increment.
AUTOMATIC ACCUMULATION
When scale is set for automatic accumulation:
1. Add a weight to the scale. The beeper sounds when
the weight is stable to indicate the weight is added.
Remove the weight.
2. Display shows
the scale returns to zero.
3. Add the next weight to continue the process.
when
4. Press ACC
5. To return to normal weighing mode, turn AU off.
FUNCTIONS
Acc
keys 1. Press TARE/^
EL Au
2. Press ZERO/ENTER
ACCUMULATED TOTAL
Scale can be set to accumulate manually or automatically.
(Refer to ACCUMULATED TOTAL in OPERATION section.)
CHANGE THE BAUD RATE
Display shows
1. Press TARE/^
4800bps or 9600bps.
2. Press ZERO/ENTER
AUTO ZERO RANGE TRACKING
Set to 0.5d, 1d, 2d and 4d.
1. Press TARE/^
2. Press ZERO/ENTER
and totals the memory when
ACC 1
NOTE: While a weight is on the scale, you can
also press ACC to store the value immediately.
In this instance, the scale will not store the
value when the weight is removed.
to display the accumulated totals.
Acc
NOTE: The scale must return to zero or display
a negative number before another sample
can be added to the memory. More items can
be added and ACC pressed again, up to 99
entries or until you exceed the weight capacity
displayed.
Tare
to select
(automatic on/off), or
to set your selection.
Zero
this is the current baud rate.
b xxx
Tare
to select: 600bps, 1200bps,
to set your selection.
Zero
to select.
Tare
to set your selection.
Zero
(manual on),
EL On
(turns off backlight)
EL Off
0621 IH-1649