For Your Safety - Würth WLA 18.0 COMPACT Traducción Del Manual De Instrucciones De Servicio Original

GB
Please read and comply with
these operating instructions
prior to initial operation of your
lamp.
Keep these operating instructions for
later use or for a subsequent owner.
Prior to first use always read the safety
■
instructions!
— Failure to observe the operating instructions
and the safety instructions could result in dam-
age to the lamp and danger for the operator
and other persons.
Unauthorised modifications and
conversions are not permitted
Modification of the lamp or manufacturing
of additional devices is not permitted. Such
modifications can result in personal injury or
malfunctions.
Only appointed and trained personnel may
■
carry out repairs to the lamp. Always use
Würth original spare parts. This will ensure the
continuing safe operation of the lamp.
Signs and symbols in these instruc-
tions
The signs and symbols in these instructions should
help you to use the instructions and the lamp
quickly and safely.
Information/tips
Provide information on the most effec-
tive or most practical use of the lamp
and these instructions.
Handling steps
■
The defined sequence of handling steps facili-
tates correct and safe use of the lamp.
3 Result
This is where the result of a handling step
sequence is described.
6

For your safety

Warning instruction hazard levels
The following hazard levels are used in these oper-
ating instructions to indicate potentially hazardous
situations and important safety rules:
A possibly harmful situation could occur and will
lead to property damage if not avoided.
General safety instructions
Protect the lamp against moisture, do not
■
immerse in water!
Do not use in an explosive environment, in
■
which there are combustible liquids, gases or
dusts. The lamp is not approved for use in such
environments.
Not suitable for children!
■
Risk of eye injuries! Do not look directly into
■
the switched on lamp!
Do not expose to direct sunlight or high levels
■
of moisture!
Avoid heat accumulation (e.g. by covering)!
■
Only use original Würth battery packs and
■
power supply units to operate the lamp. The
use of a NON-original battery pack or power
supply unit could destroy the lamp.
Always visually check the lamp for damage
■
before initial use and after transport. Ensure
any damage is repaired by trained service
personnel prior to initial use.
Use only genuine Würth accessories
■
and spare parts.
WARNING!
The hazardous situation could occur
and will lead to severe injuries and
even death if the measures are not
observed. Work with extreme care.
Attention!