EAS ELECTRIC EMR185SW1 Manual De Instrucciones página 23

Preparation before using
(Extemal display)
Warning
• Except the solutions recommended by the manufacturar, do not use mechanical
equipment or other means to accelerate defrosting.
• Except the types recommended by the manufacturar, do not use electrical appliance
inside food closet.
• T he refrigerator is provided with R600a refrigerant and cyclopentane foaming
material, and both are combustible materials. Obsoleta refrigerator should be
isolated from fire and combustion treatment is farbidden.
New refrigerator
• Remove all packing materials befare using, including bottom seating washer and
faam pads and gummed papar inside;
• Use warm and wet cleaning cloth to wipe the refrigerator's interior and exterior (add a
little detergent in the warm water and use clean water to clean up);
• Prepare a separating grounding receptacle with both polarities. Do not share multi­
purpose socket with other electrical appliances;
• Connect earth wire. Earth electrode of the socket must be equipped with a reliable
grounding wire.
2
Correct application of the refrigerator
Transportation and placement of the refrigerator
Transportation
• Do not invert, traversa, press and shake the refrigerator. When moving the
refrigerator, angla of inclination shall not be largar than 45
• When moving, do not make excessive pressure to the door or top cover, otherwise
deformation will occur.
• Slightly remove the refrigerator backward Cless than 20
distance.
Placement
• Place the refrigerator at a ventilative place, far away from heat source and direct
sunlight. In arder to avoid rust or reduce insulation result, please do not place it at
damp and watered place.
• Top space far the refrigerator shall not be less than 30cm. Distance against two sidas
shall not be less than 10cm, Distan ce against to the wall shall not exceed 75mm,
providing convenience to open and clase the door and disperse the heat.
• Place the refrigerator on a flat and sol id floor. (if it is not stable, you can regulate the
regulating legs)
Attention
Make sure the power line is not pressed by the refrigerator or other articles.
Before connect the power line, make sure the voltage range of the refrigerator
accord with that of the power supply.
Ensure that the refrigerator is placed correctly and stably.
Be aware of all safety matters needing attention.
1.Connect the electricity
After connecting electricity, it will enter into ex-factory state.
2.Put food into the refrigerator
Suggestion: after working a time, the refrigerator will arrive store temperature
or after the first stop of the compressor, put food into it, which is beneficia! to
retain freshness.
r-----------------------------------------------------------------------1
: Note: if the set temperature is altered or new food is put in, temperature
: inside the box will achieve the balance after a time, which is determined by :
: the temperature alteration degree, temperature of ambient environment, :
: opening frequency, quantity of the food inside and so on.
L-----------------------------------------------------------------------�
V.1
º
.
º
) to rear truckle roll a short
1
:
1
3 V.1