Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
AC plug
Connection
AC Live
AC Neutral
AC Ground
DMX Linking
The WELL STX 180 will work with a DMX controller using a wireless DMX data connection. A DMX Primer is available
from www.chauvetprofessional.com.
DMX connection
The WELL STX 180 uses a wireless DMX data connection for its DMX personalities: 4Ch, 15Ch, 64Ch, and 67Ch. See
the User Manual for information about connecting and configuring the product for DMX operation.
Infrared Remote Control (IRC)
The WELL STX 180 is fully compatible with the Infrared Remote Control (IRC) from CHAUVET. For more information on
the IRC, download the User manual from www.chauvetprofessional.com.
It may be necessary to turn the product off and on again when switching from W-DMX to IRC and
vice-versa.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. The WELL STX 180 supports RDM protocol that allows feedback to monitor changes to
DMX Address, DMX Channel, and Dimmer Mode menu options. Download the User Manual from
www.chauvetprofessional.com
Wireless Operation
In optimal conditions, the WELL STX 180 can operate up to 300 m (900 ft) away from the W-DMX transmitter. The
W-DMX receiver in the WELL STX 180 must be paired with the W-DMX transmitter for wireless operation.
Initial setup
1.
Turn the W-DMX transmitter on.
2.
Connect the W-DMX transmitter to a DMX controller.
3.
Place the WELL STX 180 within 300 m from the W-DMX transmitter.
4.
Turn the WELL STX 180 on.
Configuration
1.
From the WELL STX 180's control panel, go to the DMX Address.
2.
Select the start address, as with any other DMX-compatible product.
3.
Go to Wireless Setting > Operating Mode.
4.
Select Receive.
5.
Go to Wireless Setting > WDMX > On/Off.
6.
Select On.
7.
Press the reset button on the W-DMX transmitter.
Product pairing
If the WELL STX 180 has already been paired with the W-DMX transmitter, the display screen will show the DMX address
and the DMX channel in use. The WELL STX 180 is now ready to work in wireless mode.
Pairing the WELL STX 180 and a new W-DMX transmitter
1.
From the WELL STX 180's control panel, go to Wireless Setting > Receive Reset.
2.
Select Yes.
3.
From the W-DMX transmitter, press <RESET>. The signal indicator on the transmitter will flash.
4.
Once the transmitter has found the WELL STX 180, the signal indicator on the W-DMX transmitter will illuminate
solid.
5.
The display screen on the WELL STX 180 will show the strength of the signal.
W-DMX operation can be interrupted or inhibited by people or liquid masses, including water or
snow, between the transmitter and receiver. For best results, keep the area between the
transmitter and receiver clear of any liquid mass.
WELL STX 180 QRG Rev. 4
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
for more details.
Wire (Europe)
Brown
Blue
Green/Yellow
EN
Screw Color
Yellow/Brass
Silver
Green
2
Publicidad
Tabla de contenido
