BONAIRE Durango 3100 Manual Del Propietário página 7

5. Electrical Connection and Installation
Review and understand the warnings in the General Safety Information section, page 2
& 3.
1. Wheel Installation:
Insert all the five small wheels into the
round holes at the bottom.
2. Install the cooler on a flat, level surface.
3. Adjustable Up and Down louvre: The Up and
Down Louvres can be adjusted using the
protruded tab shown on Page 5.
4. Add clean water into the water tank. Check the water level
window on the front of the cooler to see when the water tank is
full.
5. Plug the unit into a 120 VAC (± 10%) 60 Hz, 1 phase GFCI
protected grounded outlet.
6. Operation
Control Panel & Remote Control
1. POWER (ON/OFF) [ ]: Press this button to switch the cooler on/off. Icon will glow with blue
colour at ON position and RED colour at OFF position.
2. COOL [ ]: Press the button to switch the pump ON/OFF. Cool Icon will glow when switched
ON. The pump will start only when there is sufficient water in the tank, indicated by water icon
glowing in WHITE. Low water level will be indicated by a buzzer for 5 seconds and water icon will
start blinking in red colour.
3. FAN [ ]: When started, the fan icon will glow. Press the button for High, Medium and Low
speeds. The selected speed will be indicated by glowing LED.
4. SWING [ ]: Press button to switch the swing function on/off. Swing icon will glow when
switched ON.
5. TIMER [ ]: Press the button to set OFF timer to 1-7 hours in intervals of 1 hr. Timer icon will
glow when timer is switched ON and the glowing LEDs will indicate the total OFF time set.
6. WATER LEVEL: The LED light is white when the tank contains enough water to operate in cool
mode. When water is lacking in tank, the LED light is red, and the cooler sounds an alarm for a
Water Level
7