Publicidad
Step 9
Carefully turn your unit over onto its front edges. Unfold one
å
of the BACKS (H) and lay it over the top of your unit.
Make equal margins along all four edges of the BACK (H).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the sides and upper edge of the BACK (H) to your unit
å
using the NAILS (1N).
NOTE: Do not nail the lower edge of the upper BACK at
å
this time.
Lay the other BACK (H) over the bottom of the unit so it
å
overlaps the upper BACK. Line up the holes in the upper edge
of the lower BACK over the holes in the lower edge of the
upper BACK.
Fasten this BACK (H) to your unit using the NAILS (1N).
å
Fasten the METAL BRACKETS (4G) to the BOTTOM (F) and
å
BASE (K). Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: There are no pre-drilled holes in the BASE (K). Use
å
fi rm pressure to turn the SCREWS into the BASE.
These overlapping holes must
line up over the SHELF (G) and
the holes in the upper BACK (H).
4G
www.sauder.com/services
nd
2
F
K
H
BLACK 9/16" LARGE HEAD SCREW
(4 used for the METAL BRACKETS)
418667
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
1N
NAIL
(52 used in this step)
H
st
1
1S
Page 13
Publicidad
