Note: To enhance the autonomy of your Aventura, you may purchase the AA battery
attachment to substitute the Li-on battery by three AA batteries.
Connection to PC (storage unit)
3.5
When TwoNav Aventura is connected to the PC by means of the USB wire, the Two-
Nav application is closed and the device becomes a "storage unit". Two new storage
units will then be shown on your PC:
•
Local disk: inner memory of the device
•
Extractable disk: SD card that may be inserted into the device.
This way you will be able to transfer data from the PC to the Aventura and vice versa.
Please note that the folders to save data in the TwoNav Aventura in the memory card
are:
•
Maps: TwoNavData\Maps
•
Data (Waypoints, routes and tracks): TwoNavData\Data
Important: While connected to the PC, TwoNav cannot be operated. If the device is
connected to another external source (car or wall charger) you will be able to do it.
3.6
Using the electronic compass
TwoNav Aventura is fitted with a digital compass so you have accurate information
available on the directions to follow even if you are stopped.
To be able to use the information supplied by the compass you must follow two steps:
1.
Adjusting the compass: Go to 'Main Menu > Configuration > Off-road >
Calibrate Compass'. Once inside the adjusting utility, place the device on a
horizontal position and just turn it slowly for a few seconds.
2.
Go to 'Main Menu > Configuration > Off-road > Bearing' and select 'Auto-
matic'. This way, the information coming from the compass will be consid-
ered when you are stopped or driving very slowly (in these cases, the GPS
information is less reliable to determine orientation).
Note: Adjustments must be made outdoors and far from sources of alterations of the
magnetic field, such as cars, buildings or electric lines. For further safety, it is recom-
mended to adjust the compass prior to any outings.
9