Beper 40.500 Manual De Instrucciones página 10

Anti-cellulite Massager Use instructions
Never touch the appliance with wet or humid hands.
Do not leave the appliance exposed to weathering (rain, sunlight)
Do not drop or hit the appliance.
In case of a breakdown or malfunctioning of the appliance, disconnect it at
once.Do not attempt to repair it, but take it to a service center approved by
the manufacturer.
The appliance is not designed for medical purposes.
Exercise extreme care when using the massager on your neck and back
area. Always make sure to updo your hair before massaging the neck and
back area, to prevent the movement of the heads from accidentally trapping
some strands of hair, causing them to tear.
Description Fig.A
1. Main unit
2. Power/massage/massage + IR switch
3. Adjustable massage intensity controller
4. Infrared light
5. Massage head adaptor
6. Cord
7. Finger massage head
8. Spiky roller massage head
9. Ball massage head
10. Wavy surface massage head
11. Protective cloth head
Tips for use
Self-massage is best done in the morning because the body is rested and more receptive. During the evening, especially
after a long day spent sitting down or on your feet, legs are already congested and additional stress may increase the
inflammatory state, so it is best to apply only cream with a light massage at this time of day.
Massage the areas to be treated in small concentric circles. The friction helps to improve local circulation. Move slowly and
fluidly, starting from the bottom up and without applying excessive pressure to the tissues.
Massaging the legs and feet is especially good for alleviating the sensation of tiredness and heaviness and promoting a
pleasant relaxed feeling.
Use instructions
Choose the desired accessory for the massage, mount it onto the hexagonal base making sure that the appliance is both
switched off and unplugged. Fig.B
Plug the appliance and place the switch to 1 position, to active the massage only, or 2 to also activate the infrared light.
Adjust the intensity of the massage with the controller.
The accessories supplied can be used interchangeably.
Check the diagram in Fig. C and D to choose the speed and the right accessory for every body area to be treated.
Use the cloth head if you are applying cream during the massage to prevent dirtying the accessories. Mount it by turning it
clockwise onto the base unit, making sure that it is properly closed.
Accessories 7 and 9 are known as multinodes due to the various shaped protrusions. Using these, you can perform a
percussion massage of varying intensity. Applying greater pressure will result in a deeper massage.
The roller accessory 8 is used to perform a vibration massage that works against cellulite thanks to the up and down move-
ment. It also promotes good blood circulation.
Accessory 10 is particularly ideal for a more delicate and less intense friction massage. It is recommended for alleviating
muscular pain from cramps due to the mild, relaxing action of the massage.
The infrared/heat function combined with vibration massage applies heat to the skin which helps absorb the nutrients from
the cosmetic products used.
Do not massage the same area for more than 5 minutes and do not run the appliance for more than 15 minutes at a time.
Before beginning a new session of massages wait at least 15 minutes until the appliance cools down.
10