Aircare EXECUTIVE 4DTS900 Serie Manual Del Usuario página 6

9
Lift the bottle end covers on each side of
the fan assembly, and place the bottles
in your Executive with the caps facing down.
10
Wait 20 minutes for the wick to become
fully saturated, then proceed to step 11.
11
Plug in your unit and press the power
button power-of .
12
Set your fan speed by pressing the
large or small
increase or decrease fan speed. Your Executive
has nine fan speeds that are displayed by F1 (the
lowest) through F9 (the highest).
Note: On higher speeds, the Executive puts out a tremendous amount
of humidity, so it's louder on these levels. Most of our customers liken it
to the sound of a box fan. Rest assured there is nothing wrong with your
unit, it's just working very hard to put out much-needed humidity.
13
Set your humidity level from 25% to 65%.
Press the large
buttons to increase or decrease the humidity
setting. The humidistat on your cord will read your
home's humidity and turn your fan off when the
set humidity level is reached. When set to 65%,
your unit will run continuously.
14
Press the crescent moon button
off the panel lights while you sleep (all of
your settings will remain set). Press any
button to turn the lights back on.
That's it! Your Executive is ready to use.
fan buttons to
or small water drop
to turn