Bosch Quigo Plus Manual Original página 21

Push the locking mechanism (4) in the direction of the arrow to open the battery
compartment cover (6) and remove the battery compartment cover. Insert the bat-
teries supplied.
When inserting the batteries, ensure that the polarity is correct according to the il-
lustration on the inside of the battery compartment.
If the batteries become weak, the laser lines will flash quickly for a few seconds.
Always replace all the batteries at the same time. Only use batteries from the same
manufacturer and which have the same capacity.
Take the batteries out of the measuring tool when you are not using it for a
u
prolonged period of time. The batteries can corrode and self-discharge during
prolonged storage.
Operation
Start-up
Protect the measuring tool from moisture and direct sunlight.
u
Do not expose the measuring tool to any extreme temperatures or vari-
u
ations in temperature. For example, do not leave it in a car for extended periods
of time. In case of large variations in temperature, allow the measuring tool to ad-
just to the ambient temperature before putting it into operation. The precision of
the measuring tool may be compromised if exposed to extreme temperatures or
variations in temperature.
Avoid substantial knocks to the measuring tool and avoid dropping it. Dam-
u
aging the measuring tool can cause accuracy to be compromised. If the laser line
is subjected to a substantial knock or is dropped, check it by comparing it to a
known horizontal or vertical reference line.
Switch the measuring tool off when transporting it. The pendulum unit is
u
locked when the tool is switched off, as it can otherwise be damaged by big
movements.
Bosch Power Tools
English | 21
1 609 92A 4J4 | (16.08.2018)