Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1: REMOVE OLD TOILET
D: REMOVE TOILET CAPS
Then unscrew hex nuts to release
toilet bowl from the floor.
9/16"
Socket Wrench
E: REMOVE OLD BOLTS FROM
THE TOILET FLANGE
F: CLEAN BOTTOM OF TOILET
Scrape off wax with putty knife and wipe clean. No wax residue
should remain.
Putty Knife
(Optional)
4
STEP 2: PLACE SETFAST
(CONTINUED)
NOTE: Pre-assemble SetFast (if needed). Thread stud into anchor nut, 2
or 3 turns only. White Dot, "thread locker", must be closest to top.
A: SLIDE YELLOW LOCK WASHER
B: INSTALL BOLT (A) INTO
(A) Brass Bolt
(B) Thread Locker
(C) Anchor Nut
(D) UP.
FLANGE SLOT.
When positioned, pull bolt up and
press down on yellow lock washer
(D) to secure.
BOLTS
™
(white dot)
(D) Lock Washer
5
Publicidad
